Control wiring is the low-voltage side of your equipment: the push buttons, switches, sensors, interlocks and relays that tell motors when to start and stop. It’s tucked inside panels and machine frames, and over the years it collects splices, unlabeled wires and changes nobody wrote down.
We install and terminate wiring for motor controls, control panels, sensors and field devices. We can wire to your drawings or the equipment maker’s, and we can trace and clean up existing control wiring that has become hard to troubleshoot.
How it works
We start with the drawings or, if there aren’t any, by tracing what’s there. Then we give you a written estimate for the wiring, terminations and checkout.
Our part is the wiring and terminations. If your system uses a PLC or other programmed controller, the programming stays with your controls integrator or equipment supplier, and we work alongside them. Before handing the equipment back, we check each device and connection with your team and label wires and terminals to match the drawings.